|
|
|
|
|
|
|
Product Features
-
Features
- Please note that these require a smart pixel controller - these will not work with dumb controllers!
- Smart / Pixel Strip
- Typically used on smaller pixel strip arch projects
- Pixel protocol WS2811 (supported by every major pixel controller including Pixie) - 800Khz Speed
- Color order RGB
- Viewing angle of 120 degrees
- Pre-Attached 6" Waterproof connections
- White PCB circuit board background
- Lights
- Total LEDs per Strip: 60 of 5mm x 5mm (5050) RGB LED Lights
- Total Individually Controllable Sections per Strip: 20 Sections (10 per meter) - each 4" in length, contain 3 RGB LED lights per section
- Total DMX channels required: 60 DMX Channels (20 sections, each with three channels - Red, Green, Blue)
- Color Output Order - RGB
- Dimensions
- Overall length is 2 meters or about 6 feet, 6 inches
- Width of strip without protective boot: .393" / 10mm
- Width of strip with protective boot: .492" / 12.5mm
- Height of strip without protective boot: .125"/ 3.18mm
- Height of strip with protective boot: .160" / 4mm
- Weather
- Silicone "boot" covers entire length of strip providing typical weather resistance
- Ends are silicone glued to ensure weather tightness
- Not intended for use underwater
- Wiring colors:
- Red = Power Input Anode/+/Positive
- Black = Power Input Cathode/-/Negative
- Yellow = Data Signal
- See photos on this page for pin out map
- Power
- 12v DC Input
- White (all three colors) Entire Roll: 1.2 amps / 14.4 Watts
- 2.4 Watts per Foot / 7.2 Watts per Meter
- Packaging
- Each strip ships on a plastic reel, packed in a plastic, anti-static envelope.
- Wiring instructions are provided on the outside of the envelope.
|
|
|
|
|
|
You might also be interested in... |
|
|
|