Kulp Lights B16A-B V1 and V2 Mounting Board to HolidayCoro HC-2500 Base Mounting Kit

Product Features
This kit includes:

Base mounting plate for the HC-2500 enclosure
- NOTE: End-plate for HC-2500, if necessary, is not included with this purchase due to the highly customized nature of the AlphaPix Flex System
Mounting screws for up to two, 350w power supplies (not included)
Screws to attach the mounting plate to the HC-2500 enclosure
Zip tie for securing input wiring to mounting plate
Hole Identification
- + = Six holes for mounting AlphaPix Flex Expansion Board (use screws from AlphaPix Flex expansion board kit)
- X = Six holes for threaded screws to mount mounting plate to the HC-2500 enclosure
- / = Eight holes (4 per PSU) for mounting two vertical power supplies
- \ = Four holes for mounting one horizontal / flat power supply
- - = Location for installing zip ties to secure low voltage (top) and power cable (bottom)
- DUAL PSU = Cut the tabs to release this support bracket to link the tops of two vertically mounted power supplies
- Right Hole = Location for power cable to come out. When using dual power supplies, supply power at top power supply
- Bottom Notch = Location to allow power input cable to run under mounting board
Not included are:
- Enclosure
- End-plate
- Power supplies
- Controller or expansion boards
- Hookup wiring
- Power input cord