SMART Long Range Support Page Last Updated: 08/23/2021
Welcome to the Long Range SMART Receiver Setup and Training Page
Subject
Video
Overview of how Long Range REGULAR and SMART technologies work and the limitations and use cases for Long Range
HinksPix PRO Controller Design Tool - Basics on how to configure 2 long range smart receivers with a megatree, 4 arches and star.
HinksPix PRO Controller Design Tool - Advanced on how to configure 4 long range smart receivers (4 SPI, 16 SPI and 16 AC) with a megatree, 4 arches, 4 candy canes, 1 matrix and legacy AC lights.
Overview of #936 Ready2Run Long Range System
16 Long Range Smart Receivers
A 16 Long Range Smart receiver is nothing more than four standard 4 SPI Long Range Smart receivers connected on one board
When you set the start address, each 16 LR Smart receiver will consume 4 sequential addresses. For example, if your starting address is zero (both switched down/off), then the board has the addresses 0,1,2,3 even though the HinksPix PRO interface only shows address 0 - internally the controller is sending data to receivers 0,1,2 and 3.
Outputs on the 16 LR Smart receiver map over as follows
LR Address
Example
Stream
(Data from CAT5 wire pair)
LR Smart 16
Output # Label
LR Smart 4
Output # Label (If 4 LR 4 were daisy chained)
