Return to DISCONTINUED: Dumb RGB 3 Channel DMX Controller / Decoder / Screw Terminals / DIP Switch Addressing

Sort By:: Most Helpful Newest Rating: High to Low Rating: Low to High	Page of 3

0 of 0 people found the following review helpful:

this is as defined, a dumb controller,but works February 9, 2017 Reviewer: mar02io from Wentzville, MO United States   I had to purchase a smart interface(e1.31 bridge to DMX).  Once I connected it to the dumb controller, all of my dumb led pixel bulbs functioned properly.  The dumb controller board is well built with good output drivers.  All is working fine. Was this review helpful to you?

0 of 0 people found the following review helpful:

review August 7, 2016 Reviewer: Joe Countryman from Merrill, WI United States   Works great!! Was this review helpful to you?

0 of 0 people found the following review helpful:

Easy to hook up July 26, 2016 Reviewer: Jonathan Fanselau from Edmond, OK United States   Works as expected. Was this review helpful to you?

0 of 0 people found the following review helpful:

Easy to use April 21, 2016 Reviewer: Mark Bell from South Euclid, OH United States   I got this controller in the mail, and between the screw terminals and easy address setting, I was blinking lights in minutes. Thanks! Was this review helpful to you?

0 of 0 people found the following review helpful:

Excellent Service January 12, 2016 Reviewer: Bill Poteat from Morganton, NC United States   Everything ordered has arrived in good condition and in a timely manner Was this review helpful to you?

0 of 0 people found the following review helpful:

Works as advertised January 7, 2016 Reviewer: Russell from CA United States   No issues with this controller set up is easy and quick. There is a channel table that comes with the controller  to make dip switch settings.  The predefined test patterns are very useful Was this review helpful to you?

0 of 0 people found the following review helpful:

first step into DMX December 19, 2015 Reviewer: Jake L. from dayton, OH United States   Very easy to use once I figured out a few things. The screw terminals really make connecting everything a snap. Couple things I didnt know when I got it; if your lights and power supply are hooked up correctly when it is plugged in, it will blink brightly once. The demo (strobes through all the channels) can be activated by turning the "10" switch to on. Finally, while it is documented, it is not clearly stated that there is a LED that blinks when DMX signal is being recieved. Was this review helpful to you?

0 of 0 people found the following review helpful:

easy setup August 28, 2015 Reviewer: Joshua S from bettendorf, IA United States   I got 4 of these to use on my arches, I love that i can set the dmx address so easily. Was this review helpful to you?

0 of 0 people found the following review helpful:

Handy April 11, 2015 Reviewer: Travis Slaughter from Coshocton, OH United States   These little things are very handy to have around if you have little things off in the distance or you are daisy chaining a long run. Was this review helpful to you?

0 of 0 people found the following review helpful:

Works Great January 4, 2015 Reviewer: Robert from Clayton, NC   I tested these and the other model that required a computer to set the address. I ended using these as the DIP switches require no programming and allowed for a quicker set up. I would buy these again. Was this review helpful to you?