Return to PixNode QuickStrip Node Installation Tool / Jig for PixNode Classic and Extreme Mounting Strip V2

Sort By:: Most Helpful Newest Rating: High to Low Rating: Low to High	Page of 5

0 of 0 people found the following review helpful:

December 15, 2024 Reviewer: Dennis Wade from Evansburg , AB Canada   Was this review helpful to you?

0 of 0 people found the following review helpful:

jig December 7, 2024 Reviewer: Jeff Henley from Statesboro, GA United States   Couldn't done without it. Was this review helpful to you?

0 of 0 people found the following review helpful:

Must have tool. December 3, 2024 Reviewer: Karl Vondrak from SUSSEX, WI United States   The PixNode quick strip installation tool was very helpful for install the 800 PixNodes. Maybe if it had some screw holes to mount onto work bench, but I ended up just holding it and sliding the strips in as needed. Was this review helpful to you?

0 of 0 people found the following review helpful:

October 6, 2024 Reviewer: Brad Burnard from Wyoming, ON Canada   Was this review helpful to you?

0 of 0 people found the following review helpful:

August 20, 2024 Reviewer: Richard Burns from Glendora, CA United States   Was this review helpful to you?

0 of 0 people found the following review helpful:

May 2, 2024 Reviewer: William Melson from Sewell, NJ United States   Was this review helpful to you?

0 of 0 people found the following review helpful:

product is good, but video isn't quite accurate February 15, 2024 Reviewer: Bob Mark from Redding, CA United States   I really like these strips. I used the link and bought a bunch of landscape stakes. No way will they fit. Did some research and found some 100 D nails. The galvanized nails are 3/8" in diameter and I was afraid I would damage the pixel stake getting them in. The nails are 1/4" diameter and although tight, I can get them in. Was this review helpful to you?

0 of 0 people found the following review helpful:

Installation Tool/Jig January 25, 2024 Reviewer: Keith Kempke from Lebanon, OH United States   Another good tool supplied to make the pixel mounting into the strips a lot easier on the builder. Glad I bought it. Was this review helpful to you?

0 of 0 people found the following review helpful:

Makes the job SIMPLE & EASIER November 28, 2023 Reviewer: Connan Lee from Eugene, OR United States   Let's be real... adding pixels in to PixNode is a tedious process. The QuickStrip tool makes it easier to set things up in a production mode and get the job done right in less time. Lightweight, easy to use. A must if you have any number of lights to install in to Pixnode. Was this review helpful to you?

0 of 0 people found the following review helpful:

Node Installation Tool / Jig May 31, 2023 Reviewer: Rusty from tavares, FL United States   Seems to be perfect for the intended job  - have not used just yet but will definitely be needed to push 800 pixels. Was this review helpful to you?