Return to 16 Output / 120 Volt Controller for Standard 120v LED and Incandescent Lights / Assembled / Ready2Run / (USA, Canada, Mexico Only) / HinksPix Pro CPU
Sort By::
Page of 1


  0 of 0 people found the following review helpful:
 
5 of 5 Excellent product and even better customer service July 27, 2021
Reviewer: Nicki and Ted Eads from Englewood, OH United States  
Betsy was incredible at handling any of my shipping concerns.  Tech support was great at  handling my tech questions.  Outstanding experience.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 July 19, 2021
Reviewer: Nicola Minniti from Long Branch, NJ United States  


Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
3 of 5 AC only December 2, 2020
Reviewer: Joel from Painesville, OH United States  
This is my first order and I went big with the AC boards.  This was purchased as a slave with possibly setting up as a stand along controller.
There was a standoff that had come loose and was laying on the PCB along with two screws.  I was able to put them back on, and checked the others screws and two others were also loose.  I was told I could return it but it would take 6+ days to get it back.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 High Quality Product - Worked as Described December 1, 2020
Reviewer: Steve W from Roseville, CA, United States  
The controller  has worked as described, was easy to setup, and to extend. Everything was packaged and assembled well.

I had a little bit of a hard time finding instructions on hooking up my Flood Light Kit with the controller over DMX. The instructions and videos were primarily written for the AlphaPix and while the interfaces are similar, the exact configuration settings and how they apply / map are not straightforward.

After some trial, error, and a couple of support requests I have everything up and working. I even have a set of Light-O-Rama boards daisy-chained over DMX working as well.

Only other suggestion I have is that it would be nice if the enclosure included a standard provision for either an RJ45 or a standard DMX connector or at least a place where one could be mounted, but this is more of a nit-pick or suggestion for an enhancement than a problem with the product.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 16 Output / 120 Volt Controller May 6, 2020
Reviewer: Susan Choate from Atlanta, GA United States  
Great quality and price!

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 December 30, 2019
Reviewer: Matthew Ryan from Fernandina Beach, FL United States  


Was this review helpful to you?

  1 of 1 people found the following review helpful:
 
5 of 5 Nice controller December 4, 2019
Reviewer: Jared from Austin TX  
I have this in my display this year, updated from a older renard based system.  The fact this allows for a higher amp per output is great!  I don't use anywhere near what they allow since everything I do is LED but having the option is nice!

WIFI & Ethernet vs the older RS485 interface is also a great improvement.

The only minor drawback is that the power outputs have no ground, but considering I don't use them anyway its not a drawback for me.

Was this review helpful to you?