Knowledge Base:  
Knowledge Base > --> Knowledge Base >
Are HolidayCoro products "Plug and Play"?
Last Updated: 08/20/2022
We are sometimes asked are our products are "Plug and Play" and this article defines what HolidayCoro considers "Plug and Play".

  • Controllers
    • Applies to controllers listed as "Ready2Run" or "Ready to Run"
    • What Ready2Run IS:
      • Controller is fully assembled into an water resistant enclosure.
      • All output cables, connectors and power plugs are fully attached
      • All outputs are labeled as to function (voltage, output #)
      • Controller has been fully factory tested as built to customer specification
    • What Ready2Run is NOT:
      • The controller is not "pre programmed" with any sequences, output configurations, IP address specific to customers computer or other per-project configuration
        • NOTE: This does not apply to specific quotes which spell out that this configuration is provided
      • Controller does not have any pre-made or configured sequences for shows or lights (excluding built-in test modes which we do not consider "sequences")
  • Props / Coro / Nets or Other Mounting Solutions
    • Applies to any product designed to hold lights sold by HolidayCoro
    • We do not sell any "Ready2Run" pre-made props excluding matrix panels where installation of pixels is sold as a cost add on service
      • NOTE: This does not apply to specific quotes which spell out that props will be installed, built or assembled on a custom basis


How helpful was this article in answering your question?

Comments / Feedback / Corrections (please, no questions):