AlphaPix Classic 4 / 16 V3 to HC-2500 Mounting Plate Adapter Kit (Door or Base)

Product Features

This adapter is designed to mount the following combinations of hardware into a CG-1500 enclosure:
- One AlphaPix 16 Pixel Controller or One AlphaPix 4 Pixel Controller
- One OR two 350 Watt Power Supplies (5v or 12v)
This kit includes all mounting screws (one or two power supplies), controller mounting plate and end-plate for the CG-2500
End-closure plate includes pre-cut holes for two 1 inch clamps, one cable gland and 1 CAT5 bulkhead mounting adapter
Kit does not include the AlphaPix 16 Controller, power supply, wiring or enclosure - all are optional
Looking for a pre-assembled controller? We have your covered: http://www.holidaycoro.com/16-Output-E1-31-Artnet-Pixel-Controller-Assembled-p/845.htm
Installation Notes:
- Power Supplies
  - One power supply - mounts flat / horizontal. Allows another power supply to be mounted on door
  - Two power supplies - mount vertical. Includes stabilizer bar (cut out from under controller)
- Hole Guide (marked on board)
  - X = Screws to mount adapter plate to HC-2500 enclosure
  - | = AlphaPix 4 mounting screw holes
  - - = AlphaPix 16 mounting screw holes
  - / = Vertical mounting of power supplies (two)
  - \ = Horizontal mounting of power supply
  - O = Dual power supplies stabilizer bar (cut tabs to release from under controller)
  - > = Zip tie mounting location
- Recommendations
  - Run power input cable through hole in mounting board and under mounting board and come out through notch at bottom of board. Use zip ties to secure low power cables on top of board and high power cable on bottom of board.
  - There are notches at the top of the mounting board to fully access the screw holes for the enclosure even with two power supplies installed.
  - The two long vertical holes are for proper ventilation of power supplies when installed vertically