 |
 |
 |
 |
|
 |
|
Product Features
-
Features
- Please note that these require a smart pixel controller - these will not work with dumb controllers!
- Smart / Pixel Nodes
- Pixel protocol WS2811 (supported by every major pixel controller)
- Viewing angle of 120 degrees
- Waterproof EasyPlug3 input and output plugs
- Lights
- Total LEDs per node: 3 (Red, Green, Blue)
- Total LED nodes per string: 50
- Total DMX channels required per string: 150 DMX Channels
- Dimensions
- Overall Length from node 1 to node 50: 19.2 feet / 230 inches
- Nominal Node to node (center) distance: ~3 inches
- Note that this dimension is a common industry method of indicating pixel spacing, additional spacing is added to allow for angles and movement in elements
- Actual node to node (center) distance: ~4.7 inches (may vary slightly from node to node)
- Lead in and lead out wire length: 6 inches (both ends) with male and female waterproof plugs
- Maximum diameter of node neck: ~11.43mm / .45" (this dimension is common for "12mm" nodes)
- Base dimensions: .75 inch x 1 inch
- Maximum height (from wires at base to top of node): 1 inch
- Weather
- Silicone body/base
- Epoxy sealed body/casing to ensure waterproof wiring and electronics
- IP68
- Wiring colors:
- Wire: 34 x 0.11mm (18 AWG) - This wire is much more flexible and allows longer runs than the standard 18 core wire in most pixels.
- Pixel direction is marked with arrows on circuit board (input side)
- Power
- Pixel direction is marked with arrows on circuit board (input side), male plug is input side
- 12v DC Input
- White (all three colors) per string (50 nodes): 3 amps / 36 Watts @ 12v DC (this amount can vary by temperature, wiring to the string and supply voltage)
- It is possible to run up to 120 of these 12v nodes, in a single string, without power injection other than at the start of the string at 100% output
|
|
|
|
|
|
| You might also be interested in... |
|
|
|
|
Just as expected 
